Table of Contents
Advertisement
Removing a Wheel Trim
The wheel trim fitted to your wheel is
retained by three of the lug nuts. The fourth
lug nut passes through the larger of the
holes and holds the wheel in position.This
allows you to remove the trim without the
need to raise your vehicle.
E186441
1.
Remove the three lug nuts as shown.
2. Remove the wheel trim.
Note: Do not loosen the lug nut diagonally
opposite to the valve stem.
Installing a Wheel Trim
WARNING
Make sure there is no grease or oil on
the threads or the surface between
the wheel lugs and nuts. This can
cause the lug nuts to loosen while driving.
1.
Install in the reverse order.
Note: Tighten the lug nuts to 133 Nm.
Ecosport (CBY) Rayong (Thailand)/Haiduong (Vietnam), enPHI
Wheels and Tires
Removing a Road Wheel
transmission, select park.
1.
2. Jack up your vehicle until the tire is
3. Remove the lug nuts and the wheel.
136
WARNINGS
Park your vehicle in such a position
that neither the traffic nor you are
hindered or endangered.
Set up a warning triangle.
Make sure that your vehicle is on firm,
level ground with the wheels pointing
straight ahead.
Switch the ignition off and apply the
parking brake.
If your vehicle has a manual
transmission, select first or reverse
gear. If it has an automatic
Have the passengers leave your
vehicle.
Secure the diagonally opposite
wheel with an appropriate block or
wheel chock.
Do not work underneath your vehicle
when it is supported only by a jack.
Make sure that the jack is vertical to
the jacking point and the base is flat
on the ground.
Do not lay alloy wheels face down
on the ground, this will damage the
paint.
Loosen each wheel lug nuts one-half
turn counterclockwise, but do not
remove them.
clear of the ground.
Advertisement
Table of Contents
