Autolock - Magnavox 27MT5005D, 27MT6005D, 32MT5015D, 32MT6015D User Manual

A
utoLock allows the viewer to block out any channels. A channel blocked by the AutoLock control cannot be viewed
until a correct access code is used to unlock the channel for viewing.
Follow these steps for Digital Mode
1
Press MENU button on
the remote control to
display the onscreen menu.
2 Press CURSOR < or
> to scroll through the
onscreen menu until
you see DTV Setup
highlighted. Press
CURSOR > to display
DTV Setup features.
3 Press CURSOR < or
> to scroll through the
DTV Setup features until
Ch. Install is highlighted.
4
Press CURSOR >
followed by CURSOR
< or > until
you see AutoLock
highlighted.
5
Press CURSOR > to
enter the AutoLock
mode.
"Password _ _ _ _" will
appear.
6
Press CURSOR >
followed by the
NUMERIC buttons on the
remote control to enter
the access code. 0711
is the default. The first
time you enter the code,
Incorrect will appear on
the screen. Enter the same
code again. Correct will
be displayed. Now can
proceed to block channels.
Note : When you are in Digital
Mode you can only
AutoLock Digital
Channels.

AUTOLOCK

Digital Mode
Main
DTV Setup
DTV Setup
Ch Install Channel Edit
Digital Audio
Weak Dig Sig
Timer AutoLock
Closed Caption Fact Ch Reset
Emerg Alert
Ch. Install
Channel Edit
Weak Dig Sig
Password _ _ _ _
AutoLock
Fact CH Reset Incorrect
Ch. Install
Channel Edit
Weak Dig Sig
AutoLock
Password _ _ _ _
Fact CH Reset
Correct
AutoLock
Block Channel
21
Follow these steps for Analog mode
Analog Mode
1
Main
Picture Timer
Sound AutoLock
Features
Active Control
2
Install
Features
Timer Access Code
AutoLock xxxx
3
Active Control
Incorrect
Features
4
Time New Code
AutoLock _ _ _ _
Active Control
5
6
NUMERIC
7
MENU
< >
Note : When you are in Analog
Mode you can only AutoLock
Analog Channels.
Press MENU button on
the remote control to
display the onscreen menu.
Press CURSOR < or
> to scroll through the
onscreen menu until you
see Features highlighted.
Press CURSOR > to
display the Features
menu.
Press CURSOR < or >
repeatedly until you
see AutoLock highlighted.
Press CURSOR > to
enter the AutoLock
mode.
"Access Code _ _ _ _" will
appear.
Using the NUMERIC
buttons on the remote
control enter the access
code. 0711 is the default.
The first time you enter
the code, Incorrect will
appear on the screen.
Enter the same code again.
You will be prompted to
enter a new code.
Use the NUMERIC
buttons on the remote
control enter the access
code of your choice.
Enter the same code a
second time to confirm
it. Once the new code is
confirmed, the AutoLock
menu will appear. You can
now access the functions
available in the menu.