Service
manual
Maintenance
Exhaust duct
Check that the exhaust duct on the back of the
dryer has not become blocked with lint or other
debris (after three months, then every three to
six months, as required).
Nonreturn flap in exhaust duct
If the exhaust duct has a nonreturn flap
(2 dryers on a shared exhaust duct), it must be
cleaned at least once quarterly.
Check that the flap is working.
Fan
After six months check that the fan has not
become blocked with lint or other debris, then
once every year, as required. Be careful not to
damage the fan wheel.
Door gasket
Standard door
Check that the loading door gasket is clean
and in good condition. Use a suitable cleaner.
Do not use solvents that may damage
sensitive plastics or painted finish.
Check that the gaskets are clean and give a
tight seal.
Sliding Door
Cleaning is the same as for Standard door,
see above.
Check that felt sealing A is intact and in good
condition.
There must be a maximum of 2 mm between
steel frame and felt, fig. 1.
The 2 doors must close parallel and the rubber
sealing B must be intact, fig. 2.
Defective sealings must be replaced.
If the doors need to be adjusted,
see section Sliding Door.
Periodic maintenance
1
A
Max. 2 mm
2
B
A
23