HUSTLER FasTrak Operator's Manual page 33

Zero-turn riding mower
Hide thumbs Also See for FasTrak:
Table of Contents

Advertisement

• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
The fuel tank is located under the seat platform with the
filler neck and fuel cap located in the left side fender.
Figure 4-4
Park the mower on level ground before filling fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
When threading the fuel cap onto the filler neck, tighten the
cap until it begins to click, then, continue to turn it until at
least three clicks are heard.
605596CE
A
A. Fuel cap
IMPORTANT: Do not overfill the fuel tank. The fuel tank
should be filled no higher than the bottom of the fill neck. The
fuel system is designed to leave room for the fuel to expand
with fuel temperature changes. Figure 4-5
Overfilling the fuel tank may cause the following:
• Engine damage
• Fire hazard!
Fill to the bottom of the filler neck
B
A. Filler neck
Use regular unleaded gasoline with an octane rating of 87
or higher. Maximum of 10% ethanol (E10) in fuel. Fuels with
greater than 10% ethanol (such as E15, E20 and E85) voids
warranty. Fuels with greater than 10% ethanol are not
approved for use and such illegal use could cause equipment
failure and pose a fire hazard.
Refer to the Engine Owner's Manual for additional fuel spec-
ification requirements.
4-3
Figure 4-4
A
Maximum
Do Not
Overfill
B. Fuel tank
Figure 4-5
REV C

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Super zX-one

Table of Contents