Installation Of Unit - LG PTAC Type Product Data Book

6RWU0-03A

2.4 Installation of unit

The PTAC and its components are as shown below.
1 3
1 4
1 2
1 5
1 6
8 1
1. WALL SLEEVE
2. FRONT GRILLE
3. AIR FILTER
4. AIR INTAKE
5. AIR DISCHARGE
Use the correct wall sleeve and outdoor grille
This unit is designed to be installed in the insulated wall sleeve.
When you place the unit into the existing sleeve, the wall sleeve
used to mount the new unit must be in good structural condition
and have the outdoor grille that securely attaches to the sleeve
or the flange of the sleeve to secure the new air conditioner.
With the LG sleeve, you can maintain the best performance of
the new air conditioner.
If you keep the existing sleeve, you run the risk of poor perfor-
mance or product failure. This is not covered
under the LG warranty.
Remove the vertical deflectors in the existing grille to reduce
condenser air recirculation that can cause the unit to poor cool-
ing or heating and component failure.
Installation
1 1
14 14 14
6. VERTICAL AIR DEFLECTOR
(HORIZONTAL LOUVER)
7. EVAPORATOR
8. CONTROL PANEL
9. POWER CORD
10. COMPRESSOR
PTAC
7 7
11. BASE PAN
12. BRACE
13. CONDENSER
14. OUTDOOR GRILLE (ARCHITEC-
TURAL GRILLE)
Outdoor Grille
Wall Sleeve
Unit
Front Grille
(Shipped with the unit)
Installation of unit
12 1
13 1
10 1
11 1
9 1
56