Using additional functions
The following additional functions are not required for normal use,
but allow you to extend the potential use of the wireless headphone
system.
Pairing one or several stethoset receivers with the
transmitter
The stethoset receiver and the transmitter of your wireless head-
phone system are factory pre-paired. The following steps are only
necessary if you want to pair additional stethoset receivers with the
transmitter.
You can simultaneously connect up to 2 paired stethoset receivers
to your transmitter.
1
Make sure that there is only one transmitter within the transmis-
sion range.
2
Place the stethoset receiver as close as possible to the transmit-
ter.
3
Switch the stethoset receiver on by pulling the ear bows apart.
4
Simultaneously press and hold the volume buttons +/-.
Receiver status
The
completed, the
Receiver status
LED light up green. The audio transmission starts.
1
3
ON
Using additional functions
LED quickly flashes green. Once paring is
LED and the
2
4
Transmitter status
RS 2000
| 21