Dell OPTIPLEX E1 Reference And Installation Manual page 135

Mini tower managed pc
Hide thumbs Also See for OPTIPLEX E1:
Table of Contents

Advertisement

7DEOH % &RQILJXUDWLRQ 0DQDJHU 0HVVDJHV
0HVVDJH
WARNING: Could not con-
figure Plug and Play Card
Name .
WARNING: Could not con-
figure PCI device,
ID= DeviceID .
Failed to configure Num-
ber of Total Count Plug
and Play ISA devices. Use
your system's configura-
tion utility to resolve
conflicts. Press any key
to continue.
WARNING: Boot Device
conflict detected!
CSN= Card Select Number
Error= Error .
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
FRQWLQXHG
3UREDEOH &DXVH
The card(s) mentioned
are not fully configured
due to resource conflicts.
One of the devices is
attempting to use one or
more resources assigned
to the system's boot
device.
&RUUHFWLYH $FWLRQ
If you do not know the allowable resource
values for your Plug and Play or PCI expan-
sion card, use the following procedure to
locate and resolve the resource conflict:

5HPRYH DOO FDUG FRQILJXUDWLRQV
IURP WKH ,&8
See "Removing a Card" in Chapter 3
for instructions.

5HERRW \RXU V\VWHP
The ICU should automatically config-
ure your Plug and Play or PCI
expansion card.

$GG WKH ,6$ H[SDQVLRQ FDUGV
EDFN LQWR WKH ,&8 UHVROYLQJ DQ\
UHVRXUFH FRQIOLFWV DV WKH\ DULVH
See "Adding a Listed Card" in
Chapter 3 for instructions.
If your Plug and Play or PCI expansion card
is not automatically configured when you
reboot the system with all other cards
removed, you should contact the manufac-
turer of the card or see the chapter titled
"Getting Help" in your Diagnostics and
Troubleshooting Guide .
Perform the following procedure:

6WDUW WKH ,&8

,GHQWLI\ WKH FDUG PDUNHG
err

This card is attempting to use one or
more resources required by the sys-
tem's boot device.

)ROORZ WKH SURFHGXUH IRU WKH SUH
FHGLQJ HUURU PHVVDJH LQ WKLV
WDEOH
ISA Configuration Utility Messages
config
B-9

Advertisement

Table of Contents
loading

Table of Contents