Dell OPTIPLEX E1 Reference And Installation Manual page 129

7DEOH % &RQILJXUDWLRQ 8WLOLW\ 0HVVDJHV
0HVVDJH
The ICU has
successfully con-
figured all Plug
and Play cards in
your system. For
the new configura-
tion to take
effect, save the
configuration, then
reboot your system.
The loaded card is
not a category
card. Press OK to
proceed.
No more DMA values
can be added.
No more interrupt
values can be
added.
No more memory val-
ues can be added.
No more I/O port
values can be
added.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
FRQWLQXHG
3UREDEOH &DXVH
The ICU has successfully
configured all of the Plug
and Play expansion cards
that were not configured
by the Configuration
Manager.
The category you have
chosen is not the correct
category under which to
add this card.
No more values are avail-
able for the resource you
are trying to add or
modify.
&RUUHFWLYH $FWLRQ
To accept these settings, save the configuration
information into NVRAM by selecting Exit from the
File menu and then selecting Yes to save. You
must reboot your system for these settings to take
effect.
Select OK. The ICU automatically opens the
correct category's dialog box. Continue the proce-
dure for adding the card as described in "Adding
a Listed Card" or "Adding an Unlisted Card" in
Chapter 3.
The maximum number of values for each resource
is as follows:
‡
4 DMA channels
‡
7 IRQ lines
‡
9 memory address blocks
‡
20 I/O ports
To free values for the resource you are trying to
add or modify, delete some of the values listed in
the resource box for the card. If your card requires
all of the values listed, contact your card manufac-
turer to resolve the issue.
ISA Configuration Utility Messages B-3