Using The Cli - Cisco Aironet 1300 Series Quick Start Manual

Using the CLI

From the privileged EXEC mode, you can reset the access point/bridge
configuration to factory default values using the CLI by following these steps:
1. Enter erase nvram to erase all NVRAM files including the startup
configuration.
2. Enter Y when the following CLI message appears: Erasing the nvram
filesystem will remove all configuration files! Continue? [confirm].
3. Enter reload when the following CLI message appears: Erase of nvram:
complete. This command reloads the operating system.
4. Enter Y when the following CLI message appears: Proceed with reload?
[confirm].
14
78-15954-02