To Register An Additional Handset; Select Base - Philips CD535 User Manual

Registration
The procedures described below are the procedures that you will find in your CD535 handset. The
procedures may vary according to the handset you want to register. In this case, please refer to the
manufacturer of the additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be
registered to one base station.
The Master PIN is required before you can register or unregister handsets. The default PIN is 0000.

To register an additional handset

1. On the base station, press and hold
procedure has to be done within 1 minute.
Within 1 minute, the base station is able to accept registration from a handset. If no key is pressed
within 10 seconds, the registration procedure will be aborted.
2. At the same time, on the handset, press
:
Registration
scroll to
3. Enter the Master PIN when prompted and press
:
4. Press to select the Base to be registered to and press
If the base is found and the PIN is correct, the unused handset numbers will be displayed and you can
select a handset number by entering the number directly.
If the PIN is incorrect,
A long confirmation tone is emitted to indicate successful registration and the screen returns to stand-by
mode.

Select Base

One CD535 handset can register up to 4 different CD535 Base stations. By default, the handset will register to
Any
BASE 1. If you select
To manually select a base station
m
1. Press MENU , scroll
m
SELECT .
:
2. Scroll to the desired base station and press
3. The handset will start searching for the base station. If the selected base is found, a long confirmation tone
is emitted.
Advanced Settings
c
for 3 seconds in stand-by mode. After that, the registration
m
MENU
m
and press SELECT
Incorrect PIN will be displayed and the handset returns to stand-by mode.
Base, the handset will register to the nearest base station.
:
Advanced Set
to
:
, scroll to Advanced Set
.
m
to start registration.
OK
m
OK to confirm.
m
press SELECT , scroll
m
to confirm.
OK
m
and press
SELECT
:
Select Base
to and press
EN
,
43