Table of Contents
Advertisement
Registration
The procedures described below are the procedures that you will find in your SE435 handset. The procedures
may vary according to the handset you want to register. In this case, please refer to the manufacturer of the
additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be
registered to one base station.
The Master PIN is required before you can register or unregister handsets. The default PIN is 0000.
To register an additional handset
1.
On the base station, press and hold
procedure has to be done within 1 minute.
Within 1 minute, the base station is able to accept registration from a handset. If no key is pressed
within 10 seconds, the registration procedure will be aborted.
2.
At the same time, on the handset, press
Registration
and press
3.
Enter the Master PIN when prompted and press
If the base is found and the PIN is correct, the unused handset numbers will be shown and you can
select a handset number by entering the number directly.
If the PIN is incorrect,
A long confirmation tone is emitted to indicate successful registration and the screen returns to previous
menu.
Unregister
To unregister a handset
m
:
1.
Press
, scroll
2.
Enter the Master PIN when prompted and press
3.
Press on the handset keypad the handset number corresponding to the handset that you wish to
unregister.
If there are no key presses within 15 seconds, the unregistration procedure will be aborted and the
handset returns to previous menu.
A long confirmation beep is emitted to indicate successful unregistration and the screen shows
Unregistered.
Advanced Settings
c
key for 3 seconds in stand-by mode. After that, the registration
m
.
OK
Incorrect PIN
will be displayed and the handset returns to stand-by mode.
Advanced Set
to
and press
:
, scroll
to
Advanced Set
OK
to start registration.
:
Unregister
OK
, scroll
to
to confirm.
OK
:
and press
, scroll
OK
and press
OK
.
43
EN
to
Hide quick links:
Advertisement
Table of Contents
