Sanyo HV-DX1E Service Manual page 70

DECK MECHANISM DISASSEMBLY
2. Plate Top (Fig. A-2-1)
1) Pull the (B) portion of the Plate Top back in direction of
arrow and separate the right side of it.
2) pull the (B') portion of the Plate Top back in direction of
arrow and separate the left side of it.
(Used tools : (-) type Drive, anything tool with sharp
point or flat point.)
NOTE
(1) When reassembling, push the Plate Top after alignment
the two position(C), (C') as Fig.
(B')
3. Holder Assembly CST (Fig.A-2-2)
1) Move the Holder assembly CST in direction of arrow and
separate the left side of it first through the (D) position of
the Chassis.
Holder assembly CST
2) Disassemble the right side of the Holder assembly CST
from each guided hole of the Chassis.
NOTE
When reassembling, insert the (E) part of the Holder assem-
bly CST in the (E') hole of the Chassis
first and assemble the left side of it.
4. Opener Door (Figure. A-2-3)
1) Turn the Opener Door clockwise and remove it through
the guide hole of the chassis.
5. Bracket assembly L/D Motor(Fig. A-2-4)
1) Unplug the Connector(C1).
(C')
(C)
(B)
Chassis
(D)
2) Unhook three Hooks(H3,H4,H5) on bottom side of the
Chassis, lift up the Bracket assembly L/M and disassem-
ble the Bracket assembly L/D Motor.
(H3)
(H5)
6. Gear Assembly Rack F/L (Fig. A-2-5)
1) Move the Gear Assembly Rack F/L in direction of
arrow(A) and unhook the Hook(H6) pulling back in front.
2) Separate the Rear Rack F/L in direction of arrow(B).
NOTE
When reassembling, align the Gear part of the Gear
Assembly Rack F/L with the Gear Drive as below Fig.
7. Arm assembly F/L (Fig. A-2-6)
1) Move the Arm assembly F/L in direction of arrow and
separate the left side of it first.
2) Disassemble the Arm assembly F/L from each guided
Hole of the Chassis.
8. Lever assembly S/W(Fig. A-2-7)
1) Hook the Spring Lever S/W on the Hook(H7) first as
below Fig.
2) Unhook the Hook(H8) in the left side of the Chassis and
move the Lever assembly S/W.
(H7)
Spring Lever S/W
4-4
Bracket assembly L/M
(H4)
Gear Rack F/L
Gear Drive
Chassis
(H8)