Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
The parameter vpn-instance vpn-instance-name can be specified only when the encapsulation
type is GRE.
Step 5 (Optional) Run:
source { source-ip-address | interface-type interface-number }
The source IP address or source interface of the tunnel is configured.
The tunnel interfaces encapsulated with the same protocol cannot be configured with the same
source address and destination address.
Whether a source address or a destination address is necessary for a tunnel interface depends on
the tunnel type. For example, an MPLS TE tunnel interface requires only a destination address
instead of a source address. If you use the interface-type interface-number parameter to specify
the source address of a tunnel, the specified interface cannot be the local tunnel interface.
Step 6 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the tunnel interface is configured.
----End

1.3.4 Checking the Configuration

Prerequisite
The configurations of the tunnel interface are complete.
Procedure
l
l
l
----End
Example
After the configuration, run the display interface tunnel command, and you can see that the
line protocol state is Up. The following is an example:
<Quidway> display interface Tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface
The Maximum Transmit Unit is 1500 bytes
Internet Address is 40.1.1.1/24
Encapsulation is TUNNEL, loopback not set
Tunnel source 20.1.1.1 (GigabitEthernet1/0/0), destination 30.1.1.2
Tunnel protocol/transport GRE/IP, key disabled
keepalive disabled
Checksumming of packets disabled
Issue 03 (2009-08-20)
NOTE
For details about the configuration of IP addresses, refer to "IP Address Configuration" in the Quidway
S9300 Terabit Routing Switch Configuration Guide - IP Services.
Run the display interface tunnel interface-number command to display information about
the VLANIF interface.
Run the display tunnel-info all command to display information about all tunnels.
Run the display tunnel-info tunnel-id command to display details about the specified
tunnel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management
1-7