Ariston CP 057 GT S Operating Instructions Manual page 22

Gas oven (CP 057 GT S):
GB
• Open the oven door (accede to the oven burner by unscrewing the two
screws indicated on the diagram by means of a tool and removing the
bottom);
• loosen the 2 screws which hold the oven burner in place, remove the
burner and replace the nozzles "N" with suitable ones for the new type of
gas according to the table "Burner and nozzle characteristics".
• re-assemble all the components, regulate the air in the burner as well as
the minimum flow of the tap.
Adjusting the low flame
• Open the door and remove the oven floor;
• put the oven knob to position maximum and light the burner;
• close the door and wait for about 15 minutes;
• put the knob to position 1 (minimum);
• remove the actual knob and regulate the adjusting screw situated above
the thermostat spindle;
• after regulating the low flame as required, with the burner lit, change from
the high to the low flame position abruptly for a few times and close the
oven door normally, making sure that the burner does not go out.
Primary air flow control
N P
R
that the opening "x" corresponds to the values in the table below. Once all
the adjustments have been made, fasten the bushing "R" with the screw "P".
Opening "X" (mm)
Burner
natural gas "G20"
Oven 6.5
Grill
22
The oven burners and grill are fitted with the
primary air control bushing "R" (gas oven
burners). The primary air flow is controlled in
an appropriate way when the flame is stable
and even, without killing the flame when the
burner is cold or lighting the nozzle when the
burner is hot.
The flow may be adjusted by loosening the
screw "P" and moving the bushing "R" so
Opening "X" (mm)
liquid gas "G30-G31"
16
5 12
Safety Chain
! In order to prevent the appliance from overturning accidentally, for
example in case of a child climbing onto the oven door, the safety
chains MUST be installed!
The cooker is provided with safety chains that must be fixed with a screw (not
supplied as accessory) on the wall behind the appliance, at the same height
as the fixing point on the appliance.
Make sure that the chains are fixed in the back of the cooker, as shown in the
drawing, in such way to be tight and parallel to the floor.
! When the installation process is complete, the chains must be kept in tension!
TABLE OF CHARACTERISTICS
Oven
33 x 54 x 38 cm
dimensions
HxLxP
Volume
lt. 78
Voltage and
230/400V~ 3N 50Hz
Power supply Max 10 kW
frequency
may be adapted for use with any type
Burners
of gas shown on the data plate.
EU Directive no 65/2014
Energy
supplementing Directive 2010/30/EU.
Label e
EU Regulation no 66/2014
Ecodesign
implementing Directive 2009/125/EC.
Standard EN 15181,
Standard EN 30-2-1
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EC dated 12/12/06 (Low
Voltage) and subsequent amendments.
- 2004/108/EC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments.
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2009/142/EC dated 30/11/09 (Gas)
and subsequent amendments.
- 2012/19/EU and subsequent
amendments.
- 1275/2008 standby/off mode.
(see data plate)