Removing A Hot-Swap Hard Disk Drive - Lenovo System x3650 M5 Installation And Service Manual

Hide thumbs Also See for System x3650 M5:

Table of Contents

The following illustration shows the cable routing for the front USB assembly.

Figure 86. Front USB assembly cable routing

Note: To connect the front USB assembly cable on the system board, press evenly on the cable.

Pressing on one side of the cable might cause damage to the cable or connector.

Replace the top cover (see "Replacing the top cover" on page 151).

Slide the server into the rack.

Reconnect the power cords and any cables that you removed.

Turn on the peripheral devices and the server.

Removing a hot-swap hard disk drive

Use this information to remove a hot-swap hard disk drive.

• To avoid damage to the hard disk drive connectors, make sure that the server top cover is in place and

fully closed whenever you install or remove a hard disk drive.

• To make sure that there is adequate system cooling, do not operate the server for more than 2 minutes

without either a hard disk drive or a filler panel installed in each bay.

Lenovo System x3650 M5 Installation and Service Guide

Front USB connector

Front USB cable