Sharp AQUOS Operation Manual page 72

>>
Using a PC
<<
Control of the TV (Continue)
Command format
Eight ASCII codes +CR
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0–9, x, blank, ?
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4
values are input for the parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response
code format".)
Any numerical value can replace the "x" on the table.
Response code format
Normal response
Problem response
(communication error or incorrect command)
Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM
POWER ON R
COMMAND SETTING
POWER SETTING P
INPUT TOGGLE I
SELECTION
TV I
*1 Select "Initial Setup" from the menu screen and set "Quick Start Mode" to "On" to enable the
Power On command for LAN and Wi-Fi.
You can "Wake On LAN (Magic Packet)" to turn on the power via LAN. It is not available on Wi-Fi
connection.
NOTE
If an underbar (_) appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL
CONTENTS.
Any numerical value can replace the "x" on the table.
ENG 7-4
COMMAND PARAMETER CONTROL CONTENTS
S P W 0 _ _ _ Off
1 _ _ _ On [RS-232C]
2 _ _ _ On [IP]
O W R 0 _ _ _ Power Off
1 _ _ _ Power On
T G D x _ _ _ (Toggle)
T V D 0 _ _ _
The Power On
command
rejected.
The Power On
command
accepted. (For
LE661U and
EQ30U models
only)
The Power On
command
accepted.
It shifts to
standby.
Power On *1
It input-switches
by the toggle. (It
is the same as
an input change
key)
It input-switches
to TV. (A
channel remains
as it is. (Last
memory))