Ford EXPEDITION 2017 Owner's Manual page 62

You can use the keypad to lock or unlock
the doors without using a key.
For vehicles without intelligent access, you
can operate the keypad with the
factory-set 5-digit entry code. The code is
located on the owner's wallet card in the
glove box and is available from an
authorized dealer. You can also create up
to five of your own 5-digit personal entry
codes.
For vehicles with intelligent access, you do
not need to enter a 5-digit entry code.
Press any button on keyless entry keypad
once to unlock all doors.
Note: You must have an intelligent access
key within 3 ft (1 m) of your vehicle.
Programming a Personal Entry Code
To create your own personal entry code:
1. Enter the factory-set code.
2. Press 1·2 on the keypad within five
seconds.
3. Enter your personal 5-digit code. You
must enter each number within five
seconds of each other.
4. Press 1·2 on the keypad to save
personal code 1.
The doors will lock then unlock to confirm
that programming was successful.
To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:
• press 3·4 to save personal code 2
• press 5·6 to save personal code 3
• press 7·8 to save personal code 4
• press 9·0 to save personal code 5.
You may also program a personal entry
code through the information display.
Expedition (TB7) Canada/United States of America, enUSA, Edition date: 201604, Third Printing
Doors and Locks
Tips:
•
•
•
Recalling Memory Positions (If
Equipped)
The programmed entry codes will recall
driver memory positions as follows:
•
•
Note: Personal entry codes 3, 4 and 5 will
not recall memory positions.
Erasing a Personal Code
1.
2. Press and release 1·2 on the keypad
3. Press and hold 1·2 for two seconds.
All personal codes will erase and only the
factory-set 5-digit code will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode
if you enter the wrong code seven times
(35 consecutive button presses). This
mode disables the keypad for one minute
and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
•
•
59
Do not set a code that uses five of the
same number.
Do not use five numbers in sequential
order.
The factory-set code will work even if
you have set your own personal code.
Entry code 1 will recall driver 1 memory
positions.
Entry code 2 will recall driver 2 memory
positions.
Enter the factory-set 5-digit code.
within five seconds.
You must do this within five seconds
of completing Step 2.
one minute of keypad inactivity
pressing the unlock button on the
remote control
switching the ignition on.