Table of Contents
Advertisement
F I R M W A R E U P D A T E S
The firmware that runs the MIDICON-2™ may need to be updated from time to time
as more features are added. You can download the latest firmware updates as well
as the MIDICON-2™ boot loader software that's used to perform the update from
www.elationlighting.com. The MIDICON-2™ firmware revision is displayed for 2
seconds in the fader page display on power up.
To perform a firmware update you will have to first install the boot loader program
on your Windows PC. Firmware updates are done over the USB connection. Power
the MIDICON-2™ while pressing in and holding down wheel 1, this will put it in
Update Mode. The Blackout LED will flash to indicate update mode. Run the boot
loader utility. If it finds the MIDICON-2™, the word "Connected" will appear at the
bottom of the boot loader dialog. Click on "Load" to select the new firmware file
(.cyacd file) then click "Program". A progress bar will appear to show when the file is
finished loading. The MIDICON-2™ will automatically reboot with the new firmware.
T E C H N I C A L S P E C I F I C A T I O N S
CONNECTIONS
USB Bus Powered (150ma 5V Max)
USB 2.0 A-Type Connector for LED Low Power Work Light (Work Light not included)
USB 2.0 B-Type Connector for Host Computer (MIDI over USB)
SIZE / WEIGHT
Length: 20.2" (514mm) | Length w/Rack Mount Sides: 19.0" (482.6mm)
Width: 12.9" (328mm)
Vertical Height: 3.6" (91mm)
Weight: 15.0 lbs. (6.8 kg)
Please Note: Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice.
www.elationlighting.com
26
Advertisement
Table of Contents
