Rack Mounting Hardware - Elation Midicon 2 User Manual

R A C K M O U N T I N G H A R D W A R E
The MIDICON-2™ comes with replacement sides so that you can rack mount it in a
standard 19" rack enclosure or case. To install the rack mount hardware you must
remove the plastic end caps then reuse the mounting screws to attach the metal
rack-mountable sides. Each side requires that you remove a total of (7) screws, (3)
on the top, (3) on the bottom, and (1) on the back. Pull the plastic end caps away
from the unit and then insert the metal rack mount sides so that the screw holes are
aligned properly. The height is 7.5 rack spaces starting from the bottom. This leaves a
gap at the top to allow room for the USB cable to fit. (See diagrams below)
www.elationlighting.com
18