Connect The Cables - COMPRO TN3230 Installation Manual

Connect the Cables

Connect Camera Using PoE
This camera supports PoE (Power-over-Ethernet), which allows electrical power and IP
data to be both delivered on a single Ethernet cable. The following instructions explain
how to connect your network camera using PoE.
1. Ethernet cable from wireless router/hub to PoE switch/router: Connect the PoE
switch/router with the wireless router/hub that has been connected to your
Cable/ADSL modem for internet connecting.
2. Ethernet port of the camera: Use the RJ-45 Ethernet cable (not supplied in the
package) to connect the Ethernet port of the network camera to the PoE port of
your PoE switch/router.
3. Make sure your smartphone is able to go to internet via your wireless router.
Using a Non-PoE Switch Wireless
Router/Hub
If you are using the camera with a non PoE capable network switch/router, please pre-
pare a PoE injector (midspan, optional) first in order to power the camera. Then connect
your camera in the following way:
1. Ethernet port on PoE injector: Use a RJ-45 Ethernet cable (not supplied in the
package) to connect the RJ-45 connector on PoE injector marked "IN". Then con-
nect the wireless router/hub.
2. Ethernet port on camera: Attach a RJ-45 Ethernet cable (not supplied in the pack-
age) from the "OUT" RJ-45 connector on PoE injector to the Ethernet port of the
network camera.
3. Make sure your smartphone is able to go to internet via your wireless router.
8 Installation
PoE Switch
(802.3af class3 Type B)
Internet
Wireless
Router/Hub
Internet