Advertisement
28
SERVI(:E
INFORMATION
Your appliance is equipped with self-diagnostic software
If you have carefully followed the recipe, reviewed the
which continuously monitors the control to ensure safe and
bakingtips in thismanual and still feel cooking resultsdo not
proper operation. If the software detects a questionable
meet your expectations, you can adjust the oven
situation, a FAULTCODE (F plus a number) will appear in
temperature. DO NOT ADJUST THE TEMPERATURE ff
the display, continuous beeps may sound and as a safety
only one or two items are not baking properly.
precaution,the operation will be cancelled,
If you think the oven should be hotter or cooler, you can
If a fault code appears in the display and continuous beeps
adjust it yourself. To decide how much to change the
sound, press the CANCEL pad. Then, reprogram the
thermostat, set the oven temperature 25°F higher or lower
cookingoperation. If the fault code reappears in the display,
than the temperature in your recipe, then bake. The results
call an authorized servicer. Do not use the oven until the
of the "test" should give you an idea of how much to adjust
appliance has been serviced,
the thermostat.
If the oven is heavily soiled, excessive smoke and flaring
TO
adjust the thermostat:
may result in a fault code during a self-clean cycle. If this I
occurs, pressthe CANCEL pad and allow the oven to cool
1. Press the OVEN TEMP pad.
for an hour.
2. Pressthe • pad until 550° is displayed.
3. Press and hold the OVEN TEMP pad for several
seconds. The display will show the ambient oven
The LOW setting should produce a stable flame when
temperature for a few secondsthen 00° willappear in the
turning the knob from HI to LO. The flame should be 1/8 inch
display.
or lower and must be stable on all ports on LOW setting.
• If 00° does not appear in the display, press the
CANCEL pad and begin again.
To adjust: Operate burner on HI for about 5 minutes to
preheat burner cap. Turn knob back to LO; remove knob,
• If the oven temperature was previously adjusted, the
and insert a small screwdriver into the center of the valve
change will be displayed. For example, if the
stem.Adjustflamesizebyturningadjustmentscrewineither
temperature was reduced by 15°. -15 ° will be
direction,
displayed.
4. Press the • or • pad to select the temgerature change
desired.
° The oven temperature can be increased up to 35° or
reduced by as much as 35° (-35 °) in 5° increments.
• If you delay in selecting a temperature, the programwill
automatically cancel and 00° will disappear. Begin
again if the program cancels.
5. Press the CANCEL Dadand the time of day wilt reappear
in the display, The oven will now bake at the aojusted
Flame must be of sufficient size to be stable on all burner
[emperature
ports. If flame adjustment is needed, adjustONLY on the LO
setting. Never adjust flame stze on a higher setting.
It is not necessary _o readjust the oven temoerature if
there is a power interruption. This aOjustment will not
NOTE: All gas adjustments should be done by a qualified
affect broil or clean temperatures.
servicer only.
Advertisement
