System Configuration - Denso BHT-604Q User Manual

BHT-604Q

1.1 System Configuration

This section describes the hardware required for the barcode data collection system used by the BHT and the BHT
software.
1.1.1 System Configuration
In addition to the BHT, the following hardware and software are required for the barcode data collection
system used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
 Host computer
 CU-600 Series (option): Communication unit
 Connection cable (option): Used to connect the BHT and host computer.
 Software: BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC 4.0 Transfer Utility (Option)
● : Required for system configuration
Host computer
(1)Connector
communication
(2) IrDA
communication
2
BHT
(1) Connector
communication
(2) IrDA
communication
CU(option)
BHT
● ●
● ●
Host computer
BHT-BASIC 4.0
Development Pack (Option)
BHT-BASIC 4.0
Transfer Utility (Option)
Wireless LAN
CU
access point
— —
●
—
Software Ref. Page
●
Page 32
●
Page 33