Epson Fast T-Jet 3 PLUS User Manual page 128

T-Jet3 PLUS User's Manual
4. Using a pair of pliers or a nut driver,
carefully loosen (do not fully remove) the
nut that attaches the black chain to the
metal carriage bracket. Do not place too
much force on the carriage bracket. The
print carriage is delicate and if not careful,
you can cause damage to it.
5. Gently lift the black chain off of the
carriage bracket. This will allow more room
to get to the ink lines.
6. Release an ink line from the cartridge by
using the quick release fi nger screw.
7. Next, hold the released ink line upwards
to allow the ink to fl ow back into the bulk
ink bottle.
Tip: A syringe can be used to force excess
ink in the lines back into the bottles by
releasing the line from the bottle and
pulling the ink through from the bottle end
of the hose.
8. Reattach the ink line to the cartridge. Do not overtighten.
9. Repeat steps 6 - 8 for all of the ink lines.
10. Next, reattach the black chain to the carriage bracket. Tighten the screws so
that the chain does not fall off.
11. Fill two 500 ml bottles (supplied) with HD cleaning solution.
12. Loosen one of the ink lines attached to the bulk ink
system bottles and connect it to one of the fi ttings on the
cleaning solution bottle.
HINT: Completing this one ink line at a time will reduce
spillage from any left over ink still in the ink lines.
Version 1.1 Revised July, 2008
118