Epson Fast T-Jet 3 PLUS User Manual page 104

T-Jet3 PLUS User's Manual
11. Fill two 500 ml bottles (supplied) with HD cleaning solution.
12. Loosen one of the ink lines attached to the bulk ink
system bottles and connect it to one of the fi ttings on the
cleaning solution bottle.
HINT: Completing this one ink line at a time will reduce
spillage from any left over ink still in the ink lines.
13. Repeat step 12 for all of the ink lines so that
each line is connected to one of the
cleaning solution bottles (CMYK for one and
white for the other).
NOTE: Take care not to let the lines tangle
up. It's important to make sure there are no
kinks or creases in the ink lines.
14. Remove one of the waste ink lines from the
waste ink bottle.
Insert the tip of a plastic syringe (included) into the
waste ink line and pull back on the plunger until
the syringe is full of liquid.
Dump the excess ink from the syringe into the
waste ink bottle or other container.
15. Repeat step 14 for the remaining waste ink line.
16. Go back to the adjustment program on your computer.
Run multiple power cleanings until the solution that comes from the waste ink
bottle is clear.
Version 1.1 Revised July, 2008
94