Eaton Fixed Master Sync Control And Master Interface Wiring Preparation; Inspecting And Unpacking The Eaton Fixed Master Sync Control Or Master Interface - Eaton 9315 Installation And Operation Manual

INSTALLATION PLAN AND UNPACKING
2.3

Inspecting and Unpacking the Eaton Fixed Master Sync Control or Master Interface

2-6
Eaton 9315/9390/9395 Fixed Master Sync Control Installation and Operation Manual
2.2.2 Eaton Fixed Master Sync Control and Master Interface Wiring
Preparation
Read and understand the following notes while planning and performing the
installation:
S
Refer to national and local electrical codes for acceptable external wiring practices.
S
Material and labor for external wiring requirements are to be provided by
designated personnel.
S
For external wiring, use 90°C copper wire with a minimum insulation rating of
600V. If wire is run in an ambient temperature greater than 30° C, higher
temperature wire and/or larger size wire may be necessary. See the applicable
wiring information in Table for the Eaton 9315 UPS, Table 3‐7 on page 3-16 for the
Eaton 9390 UPS, and the applicable wiring information in Table 3‐8 on page 3-20
for the Power Xpert 9395 UPS.
S
Use 14 AWG wiring with a minimum insulation rating of 600V for interconnections
between the Eaton Fixed Master Sync Control, the Master Interface unit, the UPS,
and the customer remote monitoring system.
S
Use Class 1 wiring methods (as defined by the NEC
30V. The wire should be rated at 24V, 1A minimum.
S
Use Class 2 wiring methods (as defined by the NEC) for interface wiring from
30 to 600V. The wire should be rated at 600V, 1A minimum and 12 AWG
maximum.
S
Sync Control dry contacts are rated at 5–30 Vdc/250 Vac at 2A per contact
(maximum load).
S
Conduit must be used when installing external wiring between the Eaton Fixed
Master Sync Control, Master Interface, and the UPS.
S
The Eaton Fixed Master Sync Control can be installed up to a maximum of 152.4m
(500 ft) from the UPS system.
When connecting the bypass and load voltage from another model UPS to an Eaton 9390 UPS or Power Xpert
9395 UPS using the Eaton Fixed Master Sync Control accessory, use Phase A, Phase B, and Neutral
connections from the other UPS. DO NOT connect the other model UPS Phase C bypass and load voltage to
the Sync Control connection point when connecting to an Eaton 9390 or Power Xpert 9395 UPS.
The unit arrives covered with protective packaging material.
1. Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact Eaton service representative
immediately.
2. Remove the protective cardboard covering from the Eaton Fixed Master Sync
Control or Master Interface unit by cutting where indicated using a knife blade no
longer than 25 mm (1").
3. Remove the plastic bag and foam packing material, and discard or recycle them
in a responsible manner.
) for interface wiring up to
®
C A U T I O N
C A U T I O N
S
P-164000023 Rev 1 www.eaton.com/powerquality