Initialisation Procedure; Wind Stop; Front Spoiler - Fiat 500C ABARTH Supplement Manual

INITIALISATION PROCEDURE

The soft top must be re-initialised after
disconnecting the battery or if the rele-
vant protection fuse is blown.
Proceed as follows:
❒ before carrying our any operation,
make sure the motor is running during the
whole initialisation procedure;
❒ keep the opening button pressed until
the soft top is completely open;
❒ when the soft top is completely open,
keep the button pressed for at least 2 sec-
onds;
❒ keep the closing button pressed until
the soft top is completely closed;
❒ when the soft top is completely closed,
keep the button pressed for at least 2 sec-
onds.
When the procedure is terminated, the
soft top will automatically carry out a com-
plete opening and closing cycle (up to 25
cm from the completely closed position)
to inform the driver that correct opera-
tion has been restored.
8
fig. 9

WIND STOP

The Wind Stop fig. 9 is designed to im-
prove driving comfort, by reducing air tur-
bulence in the passenger compartment
when travelling with the top down.
To use it:
❒ Release the backrest of the rear seat
(single or split).
❒ Attach the Wind Stop by inserting the
central part inside the rear screen guard,
with the concave part in the direction of
the passenger, as shown in the figure.
❒ Correctly re-position the backrest; the
Wind Stop is locked between the seat and
parcel shelf.
F0S0334m
fig. 10
With the Wind Stop fitted, it is still pos-
sible to move the electric hood.
When not in use, the Wind Stop should
be stored in the luggage compartment
without loading excessive weight on top
of it; do not bend.

FRONT SPOILER

The car is provided with a front spoiler
which can be raised to improve aerody-
namic comfort inside the passenger com-
partment.
To raise the spoiler, release the catch us-
ing the slider A-fig. 10 moving it to po-
sition b, as shown.
Be careful not to move the slider A-fig. 10
from position b to position a with the
spoiler raised.
F0S0308m