Ink Concentration Control - Hitachi PXR Service Manual

2.7 Ink concentration control

- Select whether or not the ink concentration is controlled based on results of the viscosity
measurement.
- Select whether or not the Ink concentration confirmation message will be displayed when
the power is turned on.
- Perform these at "stop" state
1 Confirm the IJ printer is "stop" state, and press buttons in order of
Circulation control, Next menu, Circulation environment setup and
Start/Continue in the maintenance menu, and then the Circulation env.
setup screen is displayed.
Circulation env. setup
Ink type
Ink concentration control
1 2
2 Press either [0: Disable] or [1: Enable].
0 The ink concentration is controlled by the dot count control
without measurement of the ink viscosity.
(Dot count control: Amount of ink which is used for printing
and vaporized makeup ink are automatically refilled.)
1 The ink concentration is controlled based on results of the
viscosity measurement.
Caution 1. The default is [1:Enable]
Caution 2. [1. Enable] can not be selected for some inks.
The dot count control is performed for the inks.
2011.07.07 12:45 Status:XXXXXXXXX
001 ( JP-K67
[ 1](0:disable 1:enable)
3 4 5 6 7
2-25
)
8 9 0
Decre- Incre-
Back
ment ment