IDENTIFICATION OF CONTROLS
FRONT PANEL
1
3
1 POWER INDICATOR
•
This indicator will be amber when the M32 is in standby mode.
•
When the M32 is powered up from standby mode, this indicator
will change from amber to bright white color.
2 o(STANDBY)
•
Touch the o (Standby) button on top of the unit to switch the
M32 ON from standby mode. The Power indicator will change from
amber to bright/white color.
•
Press and hold o (Standby) button until M32 switches back to
standby mode.
•
One press or touch of the o (Standby) button will not switch the
M32 to standby mode. This is intended to avoid unintentionally
setting the M32 to standby mode if one happens to just touch or
press the o (Standby) button at operating mode.
•
The Power indicator will change to amber color at standby mode.
•
The o (Standby) button cannot activate the M32 if the rear panel
POWER switch is off.
•
Refer also to +12V TRIGGER - REAR PANEL.
IMPORTANT NOTES
For the o (Standby) button to activate, the following must occur:
a The supplied power cord from the M32 must be plugged in to a
power source.
b The rear panel POWER switch must be set to ON.
3 HEADPHONE
•
A 1/4" stereo jack socket is supplied for headphone listening and will
work with conventional headphones of any impedance.
•
The volume, tone and balance controls are operative for
headphone listening. Use a suitable adapter to connect
headphones with other types of sockets, such as 3.5mm "personal
stereo" jack plugs.
6
2
4
5
4 REMOTE SENSOR
•
Point the HTRM 2 remote control at the remote sensor and press
the appropriate buttons.
•
Do not expose the remote sensor of the M32 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the M32 with the remote control.
Distance: About 23 ft. (7 m.) from the front of the remote sensor.
Angle: About 30 degrees in each direction of the front of the
remote sensor.
5 DISPLAY (TOUCH PANEL DISPLAY)
•
Displays visual and menu information according to the settings
selected.
•
The following display options are accessible via the touch panel
display - Main, Media, Mode, EQ and Setup.
•
Touch the screen to select any of the display options, to see their
corresponding menu options, or settings.
6 VOLUME
•
The VOLUME control adjusts the overall loudness of the signal sent
to the loudspeakers. The Volume control is characterized by perfect
signal tracking and channel balance. It provides a highly linear and
low noise operation.
•
Turn clockwise to increase the volume level and counter clockwise
to lower it.
•
The default volume level is -20dB.
© NAD M32
6