Specifications - NAD M32 Owner's Manual

REFERENCE

SPECIFICATIONS

All specs are measured according to IHF 202 CEA 490-AR-2008 standard. THD is measured using AP AUX 0025 passive filter and AES 17 active filter.
PREAMPLIFIER SECTION
LINE INPUT, PRE OUT
THD (20 Hz – 20 kHz)
Signal-to-Noise Ratio
Channel separation
Input impedance (R and C)
Maximum input signal
Output impedance
Input sensitivity
Frequency response
Maximum voltage output -IHF load
Tone controls
PHONO INPUT, PRE OUT
THD (20 Hz – 20 kHz)
Signal-to-Noise Ratio
Input sensitivity
Frequency response
Maximum input signal at 1kHz
LINE INPUT, HEADPHONE OUT
THD (20 Hz – 20 kHz)
Signal-to-Noise Ratio
Frequency response
Channel separation
Output impedance
GENERAL SPECIFICATIONS
LINE IN, SPEAKER OUT
Continuous output power into 8 ohms and 4 ohms
THD (20 Hz – 20 kHz)
Signal-to-Noise Ratio
Clipping power
IHF dynamic power
Peak output current
Damping factor
Frequency response
Channel separation
Input sensitivity
Supports bit rate/sample rate
Standby power
DIMENSION AND WEIGHT
Gross dimensions (W x H x D) *
Net weight
Shipping weight
* - Gross dimension includes feet, volume knob and extended rear panel terminals.
Specifications are subject to change without notice. For updated documentation and features, please check out www.NADelectronics.com for the latest information about M32.
22
<0.013 % at 2 V out
>97dB (IHF; A-weighted, ref. 500 mV out, unity gain)
>105 dB (1 kHz)
>85 dB (10 kHz)
10 kohms + 100 pF
>4 Vrms (ref. 0.1 % THD)
240 ohms
146 mV (ref. 500 mV out, Volume maximum)
±0.3 dB (20 Hz - 20 kHz)
>2 V (ref. 0.1 % THD)
Treble: ±10 dB at 20 kHz
Bass: ±10 dB at 60 Hz
Balance: -10 dB
<0.03 % at 2 V out
>80dB (200 ohms source; A-weighted, ref. 500 mV out)
>76dB (MM cartridge source, IHF; A-weighted, ref. 500 mV out)
2.38 mV (ref. 500 mV out, Volume maximum)
±0.3 dB (20 Hz - 20 kHz)
>66 mV rms (ref. 0.1 % THD)
<0.005 % at 1V out
>110 dB (32 ohms loads; A-weighted, ref. 2V out, unity gain)
±0.3 dB (20 Hz - 20 kHz)
>60 dB at 1kHz
0.5 ohm
180 W (ref. 20 Hz-20 kHz at rated THD, both channels driven)
<0.03 % (250 mW to 180 W, 8 ohms and 4 ohms)
>91 dB (A-weighted, 500 mV input, ref. 1 W out in 8 ohms)
>195 W (at 1 kHz 0.1 % THD)
8 ohms: 220 W
4 ohms: 360 W
2 ohms: 400 W
>30 A (in 1 ohm, 1 ms)
>160 (ref. 8 ohms, 20Hz to 6.5kHz)
±0.3 dB (20 Hz - 20 kHz)
>77 dB (1 kHz)
>70 dB (10 kHz)
590 mV (for 180 W in 8 ohms)
up to 24 bit/192 kHz
<0.5 W
435 x 133 x 396 mm
17 1/8 x 5 1/4 x 15 5/8 inches
9.8 kg (21.6 lbs)
18.5 kg (40.8 lbs)