Introduction; Getting Started; What's In The Box; Choosing A Location - NAD M32 Owner's Manual

WHAT'S IN THE BOX

Packed with your M32 you will find
•
Two detachable mains power cord
• The HTRM 2 remote control with 4 AA batteries
•
Four magnetic feet
• Cleaning cloth
•
USB flash drive
•
Quick Setup Guide
SAVE THE PACKAGING
Please save the box and the packaging that came with the M32. Should
you move or need to transport your M32, this is the safest container to use.
We've seen too many otherwise perfect components damaged in transit
for lack of a proper shipping carton, so please: Save that box!

CHOOSING A LOCATION

Choose a location that is well ventilated (with at least several inches to
both sides and behind), and will provide a clear line of sight, within 25
feet / 8 meters, between the M32's front panel and your primary listening/
viewing position - this will ensure reliable infrared remote control
communications. The M32 generates a modest amount of heat, but
nothing that should trouble adjacent components.

RESTORING M32 TO ITS FACTORY DEFAULT SETTINGS

1 Press and hold front panel's "Main" display.
2 Select "Factory Reset" display option.
3 Select "Yes" to reset your M32 to factory default settings or "No" if you
decide not to reset your M32.
4 Factory reset is complete when the M32 goes to standby mode.
IMPORTANT NOTE
After factory reset, wait out for at least one minute to switch back the
M32 from standby mode to operating mode. This wait time can be
bypassed by turning OFF/ON the rear panel power switch and then
press Standby button.

INTRODUCTION

GETTING STARTED

5