Yamaha TF5 Service Manual page 134

TF5/TF3/TF1
eDisplay of inspection log
RTC
PASS : RTC
USB_CONNECT
PASS : USB_CONNECT
FSW
PASS : FSW
ETHER
PASS : ETHER
BATTERY
PASS : BATTERY
The contents of execution of the inspections and the details
of the result are displayed.
rTransport buttons
Push the [PLAY] button to start the automatic inspection
sequence.
The buttons are displayed as follows during the inspection
sequence.
When interrupting the sequence, push the [PAUSE]
button.
The buttons are displayed as follows during discontinuation.
Push the [PLAY] button to resume the sequence.
Push the [STOP] button to terminate the sequence.
It can also substitute pushing "USER DEFINED KEYS"
[D] switch and "USER DEFINED KEYS" [E] switch.
134
In the case of semiautomatic judging
Operate switches on sheet PNL.
ABORT
In an inspection which judges by detecting operation of
handlers, such as the inspection of switches, the popup
screen issues directions, as shown in above fi gure.
If all operations currently displayed are detected, it
will pass the inspection and will close popup screen
automatically.
When the popup screen does not close also after
performing all the operations, it fails the inspections. In
that case, push the [ABORT] button to close the popup
screen. The contents of the failure are displayed on the log
display part.
In the case of manual judgment
ALL orange LEDs light?
FAIL PASS
In the inspection which judges by viewing state, such as
the inspection of LED, the popup screen issues directions,
as shown in above fi gure.
If the state where it is displayed can be checked, push the
[PASS] button.
If the state where it is displayed cannot be checked, push
the [FAIL] button.