Connector Board - HP Pavilion x360 Maintenance And Service Manual

Connector board

Description
Connector board (includes cable, memory card reader, USB port, and double-sided adhesive)
Before removing the connector board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
5. Remove the base enclosure (see
6. Disconnect the battery cable from the system board (see
Remove the connector board:
1. Release the ZIF connector (1) to which the connector board cable is connected, and then disconnect
the connector board cable from the system board.
2. Detach the connector board cable (2) from the battery. (The connector board cable is attached to
the battery with double-sided adhesive.)
3. Remove the two Phillips PM2.0×3.3 screws (3) that secure the connector board to the base enclosure.
4. Remove the connector board (4).
Reverse this procedure to install the connector board.
Keyboard/top cover on page
Keyboard/top cover on page
Spare part number
807527-001
28).
28).
Battery on page 33).
Component replacement procedures 39