HP Pavilion x360 Maintenance And Service Manual page 49
Convertible pc 15-bk series (model numbers 15-bk100 through 15-bk199 and 15-bk000 through 15-bk099)
Hide thumbs
Also See for Pavilion x360:
- Service manual (98 pages) ,
- Maintenance and service manual (89 pages) ,
- Product end-of-life disassembly instructions (4 pages)
Table of Contents
Advertisement
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the base enclosure (see
5.
Disconnect the battery cable from the system board (see
6.
Disconnect the WLAN module antenna cables from the WLAN module (see
NOTE:
When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board.
●
Memory module (see
●
WLAN module (see
●
Fan/heat sink assembly (see
Remove the system board:
1.
Release the ZIF connector (1) to which the display panel cable is connected, and then disconnect
the display panel cable from the system board.
2.
Detach the display panel cable (2) from the system board. (The display panel cable is attached to
the system board with double-sided adhesive.)
3.
Release the ZIF connector (3) to which the webcam/microphone module cable is connected, and then
disconnect the webcam/microphone module cable from the system board.
4.
Detach the grounding tape (4) that secures the webcam/microphone module cable to the system board.
5.
Release the ZIF connector (5) to which the power button board cable is connected, and then disconnect
the power button board cable from the system board.
6.
Detach the power button board cable (6) from the fan. (The power button board cable is attached to
the fan with double-sided adhesive.)
7.
Release the ZIF connector (7) to which the connector board cable is connected, and then disconnect
the connector board cable from the system board.
8.
Release the ZIF connector (8) to which the hard drive cable is connected, and then disconnect the hard
drive cable from the system board.
9.
Disconnect the speaker cable (9) from the system board.
10.
Disconnect the RTC battery cable (10) from the system board.
Keyboard/top cover on page
Memory module on page
WLAN module on page
37)
Fan/heat sink assembly on page
28).
Battery on page
47)
44)
Component replacement procedures
33).
WLAN module on page
37).
41
Hide quick links:
Advertisement
Table of Contents
