Sony HBD-E2100 Service Manual page 9

NOTE OF REPLACING MB1002 BOARD OR WLAN/
BT COMBO CARD
When the MB1002 board or WLAN/BT COMBO card are re-
placed, please execute the below service mode.
1. Please update FW to M16.R.157
2. Whenever replace MB1002 board or WLAN/BT COMBO
CARD please execute "Reset to Factory Default Settings"
from XMB.
Procedure:
[Home menu  Setup  Resetting  Reset to Factory Default
Settings  All Settings]
Next, go to service menu and execute "(1) Bluetooth Enable" and
"(3) Write Bluetooth device address to Registry".
Finally check one touch NFC listening function at normal power
on.
Note: The operation in this mode must use a remote commander
and TV monitor.
1. Connect this unit with TV monitor.
2. Press the button to turn the power on.
(\/1)
3. Press button in order of the [DISPLAY]  [0]  [2]  [1] 
[SUBTITLE] on the remote commander.
(Make the interval when each button is pressed within two
seconds)
4. Enter the BD service mode. The OSD menu on TV monitor can
be operated by remote commander.
5. Press [m] and Enter Diag.
6. Press [,] and Enter Bluetooth Device Test (Screen 1).
7. Enter (1) Bluetooth Enable, wait until the display show
" Status : Bluetooth Enable Successful " (Screen 2).
8. Enter (3) Write Bluetooth device address to Registry, wait until
the display show "Bluetooth Device Address" and "Status :
Write Successfull" (Screen 3).
9. Enter [RETURN] to the selection of test category.
(Screen 1)
Diag
Category: Bluetooth Device Test
Diag
Category: Bluetooth Device Test
[1] Bluetooth Enable
[2] Bluetooth Disable
[3] Write Bluetooth device address to Registry
[4] Bluetooth Inquiry Test
Status : Bluetooth Enable Successful!
(Screen 2) HELP: [UP][DOWN][ENT][RET]
(Screen 3)
Diag
Category: Bluetooth Device Test
[1] Bluetooth Enable
[2] Bluetooth Disable
[3] Write Bluetooth device address to Registry
[4] Bluetooth Inquiry Test
Bluetooth device address : 00:01:36:23:FD:CF
Status : Write Successful!
HELP: [UP][DOWN][ENT][RET]
HBD-E2100/E3100/E3200/E4100/E6100
NOTE THE BD DRIVE (BPX-7) PARTS REPLACING
The mechanism blocks except optical device of BD drive (BPX-7)
are chiefl y composed of the following parts.
• HOLDER, CHUCK ASSY
• LOADING ASSY
• COVER, DRIVE
These parts are produced by two venders, it is not compatible.
Therefore, HOLDER, CHUCK ASSY and LOADING ASSY
are supplied by one pair as repair parts. Please exchange both
HOLDER, CHUCK ASSY and LOADING ASSY at the same
time.
COVER, DRIVE need not be exchanged at the same time.
Note 1: The laser caution label is not pasted to LOADING FOR SER-
VICE. Please peel off an original laser caution label, and paste
it to LOADING FOR SERVICE when you use LOADING FOR
SERVICE.
LABEL, LASER CAUTION
LOADING FOR SERVICE
HOLDER, CHUCK ASSY
LOADING ASSY
Note 2: If laser caution label is a condition of the figure below,
it is acceptable.
Ver. 1.5
COVER, DRIVE
9