Sony HBD-E2100 Service Manual page 7

2. Pass-fail judgment of the optical device (KEM480AAA)
Perform pass-fail judgment to judge whether the repair of the optical device (KEM480AAA) is necessary.
2-1. Flow of drive section check
Confirm whether
BD (BLX-104) can be
reproduced
YES
Confirm whether
DVD (HLX-513)/
CD (HLX-A1) can be
reproduced
Note: Refer to "2-11. OPTICAL PICK-UP BLOCK (KEM480AAA), WIRE (FLAT TYPE)" (page 20) about how to remove the COVER, DRIVE.
2-2. Flow of optical device IOP check
Turn the power on,
and change function
to "BD/DVD"
Press the buttons on
the remote commander
in order of [DISPLAY],
[0], [2], [1] [SUBTITLE],
and enter the service
mode
Press the buttons on
the remote commander
in order of [8], [7], [3],
[ ], and the
dIOP value is displayed
Confirm whether the
NO
drive voltage is the
following values
Q205 pin 1 : 12 V
Q206 pin 1 : 5 V
YES
Confirm OP FFC cable
(Part No. 1-846-347-11)
and SPD FFC cable
(Part No. 1-846-349-61),
and replace it when it
has been damaged
Then, confirm whether
this unit operates
normally
YES
OK
NO
Confirm whether
value is the
specification value
Specification value:
BD : ±6 mA
DVD/CD: ±9 mA
YES
OK
HBD-E2100/E3100/E3200/E4100/E6100
Confirm F201, F202,
NO
F203 on the MB1002
board, and replace it
when it is open.
Confirm whether the
NO
optical device IOP
is normal in the
service mode
(Refer to "2-2. Flow
of optical device
IOP check")
Replace the
NO
optical device
(Refer to "3. Optical
device (KEM480AAA)
replacement")
Ver. 1.5
Replace the
NO
optical device
(KEM480AAA)
(Refer to "3. Optical
device (KEM480AAA)
replacement")
7