Disassembly Instruction - Icom IC-A14 Service Manual

SECTION 3
1. Removing the front panel
q Remove the VR knob and antenna nut.
w Unscrew 2 screws from the bottom.
e Unscrew 2 screws from the side, and remove the jack
panel.
r Take off the CHASSIS assembly in direction of the arrow
until the speaker cable appears.
t Disconnect the speaker connector from the CHASSIS
assembly, and separate the front panel and CHASSIS
assembly completely.
Antenna nut
Speaker
connector
VR knob
Speaker
cable
Jack panel
2. Removing the MAIN UNIT
q Remove the seal, VR nut and VR plate from the CHASSIS
assembly.
Seal
VR nut
VR plate
Chassis
assembly

DISASSEMBLY INSTRUCTION

2 screws
Chassis
assembly
Front panel
(Continued to right above)
3 - 1
w Unsolder total of 8 points from the shield cover then
remove it.
e Unscrew 2 screws from the side plate then remove it.
r Unscrew total of 4 screws from the MAIN UNIT.
t Unsolder total of 12 points which connecting PA UNIT
then remove the MAIN UNIT from the CHASSIS.
Shied cover
4 points
2 screws
12 points
PA UNIT
Chassis
3. Removing the PA UNIT
q Unscrew 3 screws from the PA UNIT.
w Unsolder total of 4 points then remove the PA UNIT from
the CHASSIS.
3 screws
2 points
2 points
4 points
2 screws
Side plate
MAIN UNIT
2 screws
PA UNIT