Table Of Contents - York ycul0026 Manual

UNIT NO MEN CLA TURE NAMEPLATE ENGINEERING DATA ...........................................3
CONDENSER COILS
CONDENSER COIL COMPONENTS .................................................................................. 4
FAN
FAN COMPONENTS ............................................................................................................6
PIPING
REFRIGERANT PIPING COMPONENTS............................................................................ 7
COMPRESSOR
COMPRESSOR ..................................................................................................................10
CONTROL AND POWER PANELS
CONTROL PANEL AND POWER PANEL ...........................................................................16
SENSOR HARNESS...........................................................................................................68
TRANSDUCERS, PRESSURE CUTOUTS AND TEMP SENSORS ...................................71
WIRE HARNESS CONNECTORS-FIELD REPLACEMENT PART NUMBERS ...............72
CHILLER OP TIONS
YCUL CHILLER OPTIONS - KITS ......................................................................................73
ENCLOSURE KIT OPTIONS ..............................................................................................75
REMOTE CONTROL CENTER ..........................................................................................80
REMOTE CURRENT/TEMPERATURE RESET PARTS BREAKDOWN ............................81
RECOMMENDED SPARE PARTS......................................................................................82
may result if personnel fail to observe safety precautions.
Work on electronic equipment should not be undertaken unless the individual(s) have been
trained in the proper maintenance of equipment and is (are) familiar with its potential hazards.
Shut off power supply to the equipment before beginning work and follow lockout procedures.
When working inside equipment with power off, take care to discharge every capacitor likely to
hold dan ger ous potential.
Be careful not to contact high voltage connections when installing or operating this equipment.
DO NOT be misled by the term "low voltage." Voltages as low as 50 volts may cause death.
2

TABLE OF CONTENTS

WARNING
HIGH VOLTAGE
Is used in the operation of this equipment.
DEATH OR SERIOUS INJURY
LOW VOLTAGE
FORM 150.63-RP5 (903)
PAGE
YORK INTERNATIONAL