Sharp XE-A307 Service Manual page 14

(9) INSTALLING BATTERIES
Batteries must be installed in the cash register to prevent data and pro-
grammed contents from being lost from the memory in case of acciden-
tal disconnection of the AC cord or power failure. Please install two new
LR6 ("AA" size) batteries before programming and operating the cash
register.
1) Remove the printer cover.
2) Open the battery cover next to the paper roll cradle.
3) Install two new LR6 ("AA" size) batteries.
4) Close the battery cover.
5) Replace the printer cover.
(10) INSTALLING A PAPER ROLL
(XE-A207W/B, XE-A217W/B)
Always install the paper roll even when you set the register for not print-
ing receipt in REG mode.
1) Remove the printer cover.
2) Lift up the print roller arm.
Print roller arm
3) Set the paper correctly in the paper roll cradle.
Note: Before placing a new paper roll in the paper roll cradle, cut off the
pasted (taped) part of the paper and confirm that the cut end of
the paper is straight.
Correct
4) Feed the end of the paper along with the paper positioning guides
as per the diagram.
5) While holding down the paper, slowly close the print roller arm.
Note: If the print roller arm is not securely locked, printing is not done
right. If this problem occurs, open the arm, and close the arm as
instructed above.
6) Cut off the excess paper and replace the printer cover.
7) Press the [ 2RECEIPT] key to make sure the paper end comes out
of the printer cover and clean paper appears.
Note: If the paper end does not come out, open the printer cover, and
pass the paper end between the paper cutter and the paper
guide of the printer cover, and replace the printer cover.
XE-A207/A217/A307 INSTALL
– 12 –
To the printer To the printer
Incorrect
Paper positioning
guides