9/12/2006 Step Access Point Mode Set EW-7206APg to use Access Point Mode This Access Point provides web-based configuration tool allowing you to configure from wired or wireless stations. Following instructions is using Windows XP Professional, other Windows is similar. Use a Wired Station to do the following.
Page 3
9/12/2006 Select Use the following IP Address IP Address: 192.168.2.3 (any IP address within 192.168.2.2~192.168.2.254 is available, do not use 192.168.2.1) Subnet Mask: 255.255.255.0...
Page 4
9/12/2006 Click OK, and OK again to Close Local Area Connection Properties. Go to Internet Explorer and type in 192.168.2.1, the default IP of the Access Point. In the Username/Password, enter Admin/1234 10. Click on Basic Setting, select AP, type your ESSID. Click Apply to save setting.
Page 5
9/12/2006 ESSID: The Wireless Device in the client computer will detect this SSID. You can change it or leave it as default. Step Set Wireless Security Set WEP Security. Click on Security. Select WEP, 64-bit, Hex, Key 1. Enter 10 digits Hex key in Key 1. Click Apply to save the setting.
Check if the computer connects directly to the Access Point has been set to a same range IP address with the Access Point. If EW-7206APg is connected to a router, change the default IP Address of EW-7206APg to be the same range of the router.