Replacing And Installing Clock Backup Battery - iHome iKT50 Instruction Manual

Replacing and Installing Clock Backup Battery

Note: 1 CR2450 battery is included with the unit.
Remove pull tab before using the unit.
This model is equipped with a battery backup circuit that will maintain the time and other settings in the event of a
temporary power interruption (the display is NOT maintained). When the backup battery is getting weak the Low
Backup Battery Indicator will appear at the lower left of the display. When you see this indicator you should replace
the backup battery as soon as possible.
To install/replace the backup battery:
IMPORTANT: When replacing the backup battery be sure to have the unit connected to the AC outlet to maintain all of your
settings, otherwise it will be necessary to reset them after the battery is replaced.
1. Use a Phillips scerewdriver to remove the battery door located on the bottom of
the unit. If replacing battery, remove the exhausted battery.
2. Insert 1 fresh CR2450 battery in the backup battery compartment. Make sure
the "+" side of the battery is facing toward you.
3. Replace the battery compartment door and tighten screw. Do not overtighten.
Confirm that the backup battery indicator is not flashing in the display.
Note: Make sure you dispose of batteries properly (see your local regulations)
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted,
recharged, exposed to water, fire, or high temperatures. Do not place loose
batteries in a pocket, purse, or other container containing metal objects, mix with
used or other battery types, or store with hazardous or combustible materials. Store
in cool, dry, ventilated area. Follow applicable laws and regulations for transport
and disposal.
18
K4
Using the