Install Clock Backup Battery Using The Optional Remote Control Install/Replace the Remote Control Battery To check for iPod compatibility Setting Up the iH11 Charging your iPod Listening to your iPod Listening to non-docking iPod or other portable audio devices Alarm Operation...
Page 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
• Move the DST switch on the back of the unit to +1 or -1 (adds or subtracts an hour to account for daylight saving time). • Press & Hold the Clock adj. button on the back of the unit until the display flashes.
Time Display The iH11 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC adaptor is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained.
Note: Make sure you dispose of batteries properly (see your local regulations). The Remote Control controls basic functions on the iH11 and certain iPod functions when the iPod is docked in the iH11. For best results, aim remote control towards the remote sensor on the left side of the unit.
Failure to do so may damage your iPod. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). The iH11 will not overcharge your iPod. Note that other non-docking iPods will NOT charge.
For enhanced bass, slide the EXB Expanded Bass Switch located on the back of the unit to the ON position. Note: If the playing song/music loudness is too low on the iPod itself, the iH11 may not detect that the iPod is in play mode.
Note: Please make sure your iPod has enough songs to play for one hour, otherwise please set the iPod repeat mode to ON. Note: If there is no iPod present or there is no music detected on the iPod at alarm time, the iH11 will automatically switch to buzzer alarm.
The iH11 has an independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the alarm volume. Press the Volume + and Volume – Button on the iH11 or remote control to adjust the sleep volume.
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
Please refer to your iPod manual for details on iPod operation. generation iPod or other device iH11 cannot control those iPods or other devices. Remove your iPod from the connector and check for any obstruction on the connectors in the dock and on your iPod.
Shuffle, intente bajar el volumen de su aparato. También intente apagar el amplificador de bajos Reemplace las baterías por nuevas Apunte el control remoto hacia el iH11 y manténgase a una distancia máxima de 10 pies de la unidad. Solución...
Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.