Jenn-Air W216 Use And Care Manual page 19

To set oven to start cleaning at a later time:
An automatic program of 3 hours is pre-set for an average soiled oven. For a heavily
soiled oven, program can be extended up to 4 hours.
a. For an average soiled oven: Push SELF-CLEAN button.
For a heavily soiled oven: Push SELF-CLEAN button. Turn SET dial to 4:00.
b. Push STOP TIME button. Turn SET dial to time of day desired for clean cycle
to end. The start time will be calculated.
NOTE: To prevent accidentally changing the cleaning cycle, push TIMER button
to return to time of day.
6. The cleaning process begins immediately unless the self-cleaning process has
been set for a delayed start When the oven temperature reaches 550°F, the LOCK
INDICATOR LIGHT will glow and the door cannot be opened until the temperature
drops below 550°F. DO NOT TRY TO UNLOCK THE DOOR WHILE LOCK INDI-
CATOR LIGHT IS ON. The normal cleaning process takes the time selected
on the clock plus about 45 minutes for the oven to cool down before the LOCK
INDICATOR LIGHT goes out and the door can be opened.
7. After the LOCK INDICATOR LIGHT goes out, move the DOOR LOCK LEVER
to the left. The oven door can now be opened.
8. Turn the SELECTOR AND THERMOSTAT knobs from CLEAN to OFF after the
door is unlocked.
NOTE: A fan comes on whenever the lock lever is moved to the full right position.
Therefore, the fan will continue to operate at the end of the cleaning process
until the lock lever is returned to the OFF position. The fan will also start
as soon as the controls are set for a delayed start of the self-cleaning process.
To stol, cleaning process before lock indicator light comes on:
1. Move the DOOR LOCK LEVER to the left.
2. Turn SELECTOR and THERMOSTAT knobs from CLEAN to OFF.
3. Push SELF-CLEAN button.
To stop cleaning process after lock indicator light comes on:
1. Push SELF-CLEAN button.
2. Leave the THERMOSTAT and SELECTOR knobs in the CLEAN position.
3. Allow oven to cool until the LOCK INDICATOR LIGHT goes out. This may take
up to 45 minutes, depending on how long the oven has been on.
4. After LOCK INDICATOR LIGHT goes off, move the DOOR LOCK LEVER to
the left.
5. Turn SELECTOR and THERMOSTAT knobs from CLEAN to OFF.
NOTE: A fan comes on whenever the oven is set for self-clean. If the fan does
not operate contact your Jenn-Air Authorized Service Contractor for service.
2O