Milling A Rectangular Spigot - Cycle76 - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

9.6.4

Milling a rectangular spigot - CYCLE76

Programming
CYCLE76 (RTP, RFP, SDIS, DP, DPR, LENG, WID, CRAD, PA, PO, STA, MID, FAL, FALD, FFP1, FFD, CDIR, VARI, AP1,
AP2)
Parameters
Parameter Data type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
LENG REAL
WID REAL
CRAD REAL
PA REAL
PO REAL
STA REAL
MID REAL
FAL REAL
FALD REAL
FFP1 REAL
FFD REAL
CDIR INT
VARI INT
AP1 REAL
AP2 REAL
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
Description
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
Spigot length
Spigot width
Spigot corner radius (enter without sign)
Reference point of spigot, abscissa (absolute)
Reference point of spigot, ordinate (absolute)
Angle between longitudinal axis and first axis of plane
Maximum depth infeed (incremental; enter without sign)
Final machining allowance at the margin contour (incremental)
Finishing allowance at the base (incremental, enter without sign)
Feedrate on contour
Feedrate for depth infeed
Milling direction (enter without sign)
Values:
0: Down-cut milling
1: Conventional milling
2: With G2 (independent of spindle direction)
3: With G3
Machining type
Values:
1: Roughing to final machining allowance
2: Finishing (allowance X/Y/Z=0)
Length of blank spigot
Width of blank spigot
177