Yamaha RX-V1900 Owner's Manual page 98

Advanced setup
Press FID repeatedly using a ballpoint pen or
similar object on the remote control to select the
desired remote control ID.
Each time you press FID, the remote control ID indicator
changes as shown below.
ID
y
To set the remote control ID of the simplified remote control,
see page 93 for details.
■ Tuner frequency step
(Asia and General models only)
Use this feature to set the tuner frequency step according
to the frequency spacing in your area.
Choice
AM10/ Select this setting for North, Central and South
America.
FM100
AM9/FM50 Select this setting for all other countries.
■ Bi-amplifier mode
Use this feature to activate or deactivate the bi-amplifier
function.
Choice
ON Select this setting if you want to activate the bi-
amplifier function.
OFF Select this setting if you want to deactivate the bi-
amplifier function.
Note
When "BI-AMP" is set to "ON", the SURROUND BACK
terminals cannot be used to connect surround back speakers in
that the terminals are already used for the bi-amplifier
connection (page 14).
94
En
ID1
ID2
TUNER FRQ STEP
Descriptions
BI-AMP
Descriptions
■ Parameter initialization
Use this feature to reset the parameters of this unit to the
initial factory settings. You can select the category of
parameters to be initialized.
Choice
DSP Select this setting to initialize all the parameters of
the sound field parameters (page 59).
PARAM
VIDEO Select this setting to initialize all the parameters in
"VIDEO MENU" and "OSD SHIFT" and "GRAY
BACK" in "DISPLAY SET".
ALL Select this setting to initialize all the parameters of
this unit.
CANCEL Select this setting to cancel the initialization
procedure.
y
To initialize the parameters of each sound field program, use
"INITIALIZE" in the sound field program menu (
■ HDMI monitor check
Use this feature to activate or deactivate the monitor check
function of this unit.
Choice
YES This unit receives the information of the available
video signal resolutions from the video monitor
connected via HDMI and you can only select the
resolutions supported by the video monitor in
"HDMI RES." (page 73).
SKIP You can select any resolution in "HDMI RES."
(page 73).
INITIALIZE
Descriptions
).
page 59
MONITOR CHECK
Descriptions