Connecting An Av Amplifier; Using Digital Audio Output; Connecting A Usb Hard Disk Drive (Hdd); Connecting To The Network - Sharp AQUOS LX959H Operation Manual

Preparation
When using RGB cable (commercially
available) connecting to a PC (see page 72 )
NOTE
•
Macintosh adaptor may be required for use for some
Macintosh computers.

Connecting an AV amplifier

Set Top Box (STB)
HDMI-certified cable
(commercially available)
HDMI OUT
HDMI
IN
NOTE
• If the image is not in sync with the audio, check the settings
of the connected surround system.
• Letting the TV output the audio to an AV amplifier:
- When you connect ARC-compatible equipment, use the
HDMI 3 (ARC) terminal.
- If the equipment to be connected is not compatible with
the ARC, connect an optical fibre cable.

Using digital audio output

It is possible to output audio through the DIGITAL
AUDIO OUTPUT terminal. PCM or Bitstream (Dolby or
DTS Digital audio) outputs from the terminal.
NOTE
• The DIGITAL AUDIO OUTPUT terminal usually outputs the
same audio from the speakers. (The audio of the content
you are viewing is output from the terminal.)
• The DIGITAL AUDIO OUTPUT terminal does not output
some signals, depending on devices and software.
7
HDMI
OUT
Optical fibre cable
(commercially
available)
To optical digital input of
external audio devices

Connecting a USB hard disk drive (HDD)

You can use USB3 (HDD) terminal when connecting a USB
hard disk drive.
PC

Connecting to the Network

See pages 75 to 76.

Insert a SD/SDHC memory card

It provides access to photos, video, music, and other
files in SD/SDHC memory cards.
Insert a SD/SDHC memory card that stores your files
into the SD slot. Refer to the method of playing files
ARC
stored in the multimedia device specified on Page 84
for details.
(DC 5V 900mA)
NOTE
• Insert the memory card into the slot in the direction shown
in the figure.
• The SD slot supports SD and SDHC memory cards.
However some memory cards may not be supported.
• This product supports memory cards with a maximum
storage of 32 GB. We recommend that you use a memory
card with at least a speed of Class 4 for a higher read-write
speed, thus guaranteeing the system performance.
• Unplug the memory card after you have safely unloaded it
or the TV has been turned off.
• Do not unplug the memory card while data is being
transferred. Otherwise the TV may malfunction.
• Regularly back up data in the memory card to prevent data
corruption or operating errors of the TV. (SHARP shall not
bear any responsibility for data corruption or destruction.)
3
USB hard disk drive
SD/
SDHC
19