Pressure Sensor - Philips FlexCare Platinum Connected Directions For Use Manual

Pressure Sensor

Battery status (when handle is not on charger)
Features
Pressure Sensor
Note: to adjust the intensity level to the next
higher or lower level, you can press the + button
to increase intensity or the - button to decrease
intensity at any time during the brushing cycle.
A change in vibration (and a slight change in
sound) alerts you when you apply too much
pressure while brushing. See chapter 'Features'.
-
1 yellow LED indicates a low charge.
-
3 green LEDs indicate a full charge.
Note: If you hear two sets of five beeps and the
yellow LED of the battery level indicator flashes,
your Sonicare will turn off until placed on the
charger, where it will start to recharge.
Note: Your Sonicare will not be able to run a
brushing routine until it is fully recharged.
Note:To keep the battery fully charged at all times,
you may keep your Sonicare on the charger when
not in use.
This Philips Sonicare model comes with the Pressure
Sensor feature activated. The Pressure Sensor works
in all 3 modes and at all 3 intensity levels.
Activating or deactivating the Pressure
Sensor feature
1 Attach the brush head to the handle.
2 Place the handle in the plugged-in charger or
sanitizer.
15
English