Toshiba Satellite M20 Maintenance Manual page 234

4.21 Sharp 14.1-inch FL
4.
Using the U-shaped edge of the bezel as a "hinge," raise the edge of the bezel from which the clips have
been removed. Then remove the bezel. Peel off the tape for
Tape for ground
wire fixing (J)
5. Flip the bezel over and remove the two screws (E) and lamp cover (F). Then replace the
lamp unit (G) with a new one.
Maximum allowed
releasing torque is
0.1078N･m (1.1kgf･cm ).
Satellite M20 Maintenance Manual
Figure 4-65 Removing the bezel
Figure 4-66 Removing the lamp cover
4 Replacement Procedures
GND wire fixing (J).
U-shaped edge
of the bezel
4-83