Installing The Mdc Card - Toshiba Satellite M20 Maintenance Manual

4.1 General

Installing the MDC Card

Install the MDC card according to the following procedures and Figures 4-6 and 4-7, after
checking that the computer is turned off in boot mode.
CAUTION: Install the MDC card after turning off the computer. If this is violated, the
computer or MDC card can be damaged.
CAUTION: Do not touch the connectors on the MDC card or in the computer.
Contaminated connectors can cause MDC card failures.
1. Connect the MDC cable to the connector PJ1 on the MDC card.
2. Connect the MDC card to CN501 on the system board.
3. Fix the MDC card with the two M2.2x4 white bind screws.
4. Install the MDC cover.
5. Fix the MDC cover by fastening one M2.5x4 white bind screw.
After the computer is turned on, check the hardware configuration in the Hardware Setup or
TSETUP program to make sure that the installed MDC card has been recognized by the system.
If it has not been recognized yet, check the connections.
Satellite M20 Maintenance Manual
4 Replacement Procedures
4-17