Remote Controller And Its Fuctions; Parts Name Of Remote Controller - Toshiba RAS-B10GKVP-E Service Manual

9-5. Remote Controller and Its Fuctions

9-5-1. Parts Name of Remote Controller

1
Infrared signal emitter
Transmits signal to the indoor unit.
2
button
Press the button to start operation.
(A receiving beep is heard.)
Press the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor unit,
press the button twice.
3
Mode select button (MODE)
Press this button to select a mode.
Each time you press the button, the modes cycle in
order from A : Auto changeover control,
: Cool, : Dry,
(A receiving beep is heard.)
4
Temperature button (
.. The temperature setting is increased to 30°C.
.. The temperature setting is reduced to 17°C.
(A receiving beep is heard.)
5
Fan speed button (FAN)
Press this button to select the fan speed.
When you select AUTO, the fan speed is automati-
cally adjusted according to the room temperature.
You can also manually select the desired fan speed
from five available settings.
(LOW , LOW + , MED
HIGH ) (A receiving beep is heard.)
6
Auto louver button (SWING)
Press this button to swing the louver.
(A receiving beep is heard.)
Press this button again to stop the louver from
swinging. (A receiving beep is heard.)
7
Set louver button (FIX)
Press this button again to adjust the air flow
direction. (A receiving beep is heard.)
8
ON timer button (ON)
Use this button to change the clock and ON timer
times.
To move up the time, press
button.
To move down the time, press
button.
9
OFF timer button (OFF)
Use this button to change the OFF timer times.
To move up the time, press
button.
To move down the time, press
button.
10
Reserve button (SET)
Press this button to store the time settings.
(A receiving beep is heard.)
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
: Heat and back to A.
)
TEMP
, MED +
of the "ON "
ON
of the "ON "
ON
of the "OFF "
OFF
of the "OFF "
OFF
www.heronhill.co.uk
11
Cancel button (CLR)
Press this button to cancel the ON timer and OFF
timer. (A receiving beep is heard.)
12
High power button (Hi POWER)
Press this button to start high power operation.
13
Memory button (MEMO)
Press this button to ready for storing the settings.
Hold down the button for more than 3 seconds to
store the setting indicated on the remote controller
and until the
14
Automatic operation button (AUTO)
Press this button to operate the air conditioner
automatically. (A receiving beep is heard.)
15
Economy button (ECO)
Press this button to operate the air conditioner
economically.
16
PRESET button
Press this button to operate the air conditioner to
the settings stored using the MEMO button.
17
PURE button (PURE)
Press this button to start the electrical air purifying
operation.
Press the button again to stop operation.
18
Sleep time button (SLEEP)
,
Press this button to start the sleep timer (OFF
timer) operation.
You can select the OFF timer time from among four
settings (1, 3, 5 or 9 hours).
4
17
3
MODE
2
7
12
HiPOWER
6
SWING
11
CLR
CLOCK
8 RESET
– 69 –
mark is displayed.
1
14
AUTO
PURE
TEMP
PRESET
15
13
ECO
MEMO
1 . 3 . 5 . 9H
FIX FAN SLEEP
10
SET
ON OFF
CHECK
Fax: 01823 665807
16
5
18
9