Toshiba RAS-B10GKVP-E Service Manual page 119

No. Part name
7 Pulse motor 1. Detachment
valve coil
1) Perform work of item
2) Release the coil from the notch by turning it,
2. Attachment
1) Put the coil deep into the bottom position.
2) Fix the coil firmly by turning it to the notch
The pulse motor valve has A, B, C and D
room side.
After mounting it, check that coil at B room
side (Nothing is marked on the pulse motor
valve.) is connected to CN702.
Check that coil at C room side (Red marking
is marked on the pulse motor valve.) is
connected to CN703. Check that coil at D
room side (Blue marking is marked on the
pulse motor valve) is connected to CN704 of
the control board assembly respectively.
Fan guard 1. Detachment
8
1) Perform work of item
2) Remove the front cabinet, and put it down so
Perform work on a corrugated cardboard,
cloth, etc. to prevent flaw to the product.
3) Remove the hooking claws by pushing minus
2. Attachment
1) Insert claw of the fan guard in the hole of the
After all the attaching works are complected,
check that all the hooking claws are fixed to
the specified positions.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
and
1
and remove coil from the pulse motor valve.
position.
.
1
that fan guard side directs downward.
screwdriver according to the arrow mark in the
right figure, and remove the fan guard.
air outlet panel.
Push the hooking claws (5 positions) by hands
and fix the claws.
– 119 –
www.heronhill.co.uk
.
2
Lead wire
take-out port
ID mark
ID mark
Pulse Motor Valve (PMV) Coil
Set the positioning bracket on
the PMV coil to a concavity at
PMV unit side and fix PMV coil.
In this time, match color of ID
mark at the coil side with that of
ID mark at the PMV unit side.
Make sure also that pipes do
not deform when inserting and
fixing the coil.
Remarks
Positioning bracket
at coil side
PMV coil
Positioning concavity
at PMV unit side
(72˚ pitch)
PMV unit
Mounting Method of
Minus screwdriver
Hooking claw
Fax: 01823 665807